Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
PGT Fence Installation: The West Palm Beach Owner’s Guide
PGT fence installation in West Palm Beach typically runs between $3,500 and $9,000 for a complete replacement, which covers tear-out of the old fence, new posts, panels or pickets, hardware, and a clean job site when we leave. We stock common PGT-compatible fence components on the truck, and most straight-run installs finish inside two days once materials are on site. The way most homeowners find out their fence has failed is quieter than they expect: a gate that drags, a post that leans after a storm, or a bottom rail that’s rotted through where the sprinklers hit it every morning. By the time it’s visible, the fix is usually a full section replacement, not a patch.
Which PGT Models This Applies To
PGT does not manufacture a standalone fence line under their own badge, so when we say PGT fence installation in West Palm Beach, we’re talking about fence styles the company specifies alongside their impact-rated window and door products, most often aluminum perimeter fencing, aluminum pool fences, and vinyl privacy fencing matched to PGT coastal design packages. The practical matter is this: PGT’s documented wind and impact ratings apply to the glazing and door systems, not the fence line, but many West Palm Beach homes built or retrofitted with PGT products after the 2004-2005 hurricane season also received matching aluminum or vinyl fences from the same contractor, and that’s the stock we’re asked to match.
Elmstead Remodeling West Palm Beach is an independent service provider, not affiliated with PGT. When we quote a replacement, we match the fence to the existing post spacing, rail profile, and picket dimensions rather than assuming a brand label on the old materials means much. Aluminum fences need a post every 6 or 8 feet depending on the wind zone; vinyl needs reinforcement inside every corner and gate post. Those measurements tell us more than any sticker left on a post cap.
Styles & brands we work with
Signs Your PGT Fence Installation Is Failing
- Gate drag or a latch that won’t catch. This usually means the gate post has shifted in the ground, not that the hardware failed. In West Palm Beach’s sandy, wet soil, even a properly set post can drift half an inch after a few heavy rainy seasons, and the latch is the first thing to complain.
- Leaning posts after a storm. If a post moves more than an inch at the top, the concrete footing has likely cracked or the post was never set deep enough. Patching the base won’t hold; the post has to come out and be reset at the correct depth.
- Rotted bottom rails on vinyl or wood-rail fences. Sprinkler overspray and standing water after afternoon thunderstorms eat the bottom rail from the underside. You’ll see the rail sag between posts before the fasteners fail.
- White oxidation or pitting on aluminum rails and pickets. Salt air from the Intracoastal accelerates this. It starts as a chalky powder and, left alone, turns into pitting that weakens the rail walls, especially at connection points.
- Rattling pickets or panels in moderate wind. Loose pickets mean the fasteners have worn the holes oblong, and tightening them again only buys a few months. New stainless steel fasteners and fresh pilot holes are the real fix.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a typical West Palm Beach residential fence, full replacement lands between $3,500 and $9,000 installed. The spread is driven by three things: linear footage, soil conditions at post locations, and whether we’re matching aluminum (higher material cost, faster install) or vinyl (lower material cost, more careful post work). A 100-foot aluminum pool fence with two gates sits at the lower-middle of that range; a 150-foot vinyl privacy fence with a corner and a double gate sits at the upper end. Every quote is a written, line-item price before any work starts: post count and depth, rails by length, pickets or panels by quantity, hardware, haul-away, and clean-up. That price doesn’t change once the crew arrives. The finished installation carries the 365-Day Done Right Promise: if something isn’t right after the job is complete, we make it right.
DIY or Call Us?
What a homeowner can safely do is check the obvious: look for sprinkler heads throwing water against the bottom rail, tighten a loose latch plate, and take note of which posts have moved after a storm. That information helps us give a faster, more accurate estimate over the phone. What goes wrong with DIY fence work in West Palm Beach is almost always the posts. Setting a post in sand and coral requires a deeper footing than most weekend installs call for, and a post that’s off by two degrees shows up as a gate that won’t close six months later. Aluminum rail cuts need a miter saw with a non-ferrous blade; vinyl expands and contracts enough in Florida sun that butt joints need real clearance, not a tight fit. If the gate hardware is the problem, that’s the one place we’d ask you not to improvise: a heavy gate under spring tension can injure a hand fast. Call us at (728) 203-3270 and we’ll walk the site, give you a written price, and set a date.
FAQs
Vinyl fencing in West Palm Beach typically lasts 20 to 25 years before the rails and pickets begin to bracket from UV exposure and heat. Aluminum fencing lasts longer structurally, often 25 to 35 years, but the powder coat finish will show chalk-up and pitting sooner in salt-air neighborhoods. Both materials outperform pressure-treated wood in coastal Florida, which is why most PGT-era fence replacements we handle are aluminum or vinyl. Call (728) 203-3270 for an exact assessment based on your fence line’s sun and salt exposure.
Yes, and we quote it as two separate lines: the repair price and the full-replacement price. A single leaning post can be reset without touching the rest of the fence if the adjacent rails are still sound. The honest limit is this: once more than a third of the posts have moved or the rails show structural cracking, replacement is cheaper per year of service than continued section-by-section repair. Estimates are free and always in writing.
Most straight-run fence replacements in West Palm Beach are finished in one to two working days, including haul-away of the old materials. Corner lots with double gates, pool code requirements, or difficult soil at post locations add a day. The written estimate includes a firm start and end window, and Graham Stein walks the site before the first drop cloth goes down to confirm access and post locations.
We stock common aluminum rail and picket profiles, stainless steel fasteners, vinyl post stiffeners, and gate hinges and latches on the truck, so most repairs don’t require a second visit. When a specific profile needs to be ordered, we’ll tell you the lead time before you sign anything. Alongside fence hardware, we keep parts for other named brands we service, including KraftMaid, Cambria, and Silestone, so mixed-material projects don’t stall on one missing component.
If your fence is leaning, dragging, or just tired, call (728) 203-3270. Graham will walk the site himself, put the price in writing, and the crew will leave your yard cleaner than they found it. That’s how we’ve worked in West Palm Beach since the day we opened.
Written by Graham Stein, Owner, Elmstead Remodeling West Palm Beach at Elmstead Remodeling West Palm Beach, serving West Palm Beach and nearby areas.
