Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Roofing: The West Palm Beach Owner’s Guide
If you have a Unilock roof and something has failed, we stock and install Unilock-compatible roofing parts in West Palm Beach, with most roof repairs running $400 – $1,800 installed and full replacements between $8,000 – $20,000 depending on square footage and underlayment condition. You’ll usually notice the problem the morning after a South Florida storm: a water stain blooming across the ceiling, a shingle in the driveway, or granules collecting in the gutter. We’re an independent service provider, not affiliated with Unilock, but we know these roofs well enough to match the part, the profile, and the color before the first nail goes in.
Which Unilock Models This Applies To
Unilock is better known in West Palm Beach for pavers than roofing, so when a homeowner says “Unilock roof,” we always ask one question first: is this a Unilock paver roof deck system, or is Unilock the membrane and flashing brand on a flat or low-slope roof? These are different things requiring different parts. On paver roof decks, Unilock stones sit on pedestals over a waterproof membrane; the failure is rarely the stone. It’s the membrane beneath, or a cracked pedestal from a shifted stone, or a clogged drainage channel. On the roofing side, Unilock-compatible membranes are typically EPDM or TPO sheets, and the parts that fail first are seam adhesives, termination bars, and pipe boot flashings.
Before calling us, check for a manufacturer label on the membrane or an engraved mark on the underside of a paver. That tells us whether we’re matching Unilock’s 24×24 or 16×16 paver series, or whether the membrane is 45-mil or 60-mil EPDM. For pavers, aftermarket equivalents from Belgard or Tremron often match color and tolerance well, but the profile matters: Unilock’s Series 3000 has a different edge bevel than Series 6000, and the wrong stone will telegraph the patch for a decade. For membrane work, we use Firestone or Carlisle branded EPDM and TPO, which hold up better in salt air than unbranded sheet goods.
Styles & brands we work with
Signs Your Unilock Roofing Is Failing
- Water stains on ceilings after a storm. In most cases this means a seam in the membrane has separated or a pipe boot has cracked, not that the whole roof is shot. South Florida’s heat cycles stretch EPDM seams until the adhesive lets go, usually around year 12-15.
- Pavers rocking or sitting proud. A paver that moves when you step on it has a broken pedestal underneath, and that broken pedestal is now rubbing against the membrane every time someone walks the deck. This is the one to fix early; it only gets more expensive.
- Granules in the gutter or downspout. If you have a shingle-style Unilock-compatible roof, granules shedding means the shingles are past mid-life. In West Palm Beach’s UV exposure, that’s often around year 10-14, earlier than a roof in Ohio would show the same wear.
- Bubbling or blistering on the roof surface. Trapped moisture under the membrane expands in the heat. A small blister can be repaired; a field of blisters means the membrane has failed and a new overlay is the honest fix.
- Persistent damp smell in the attic or top floor. You may not see a stain yet, but slow seepage at a flashing point is already happening. This is when a repair is cheapest.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
A targeted repair on Unilock-compatible roofing in West Palm Beach runs $400 – $1,800 depending on what failed. A seam re-adhesion might be $400 – $700; a pipe boot replacement with new flashing runs $500 – $900; pulling and re-bedding a pavers section over a new pedestal system might be $1,200 – $2,500 if there’s membrane remediation needed. A full flat roof replacement in this market runs $8,000 – $20,000, and that number moves mostly on square footage, tear-off, and whether the decking below has rot from deferred maintenance.
Every estimate from Elmstead Remodeling West Palm Beach includes a written, line-item price before any work starts. You’ll see the membrane brand, the mil thickness, the paver series and quantity, the labor hours, and a firm start and end window. No change orders because we found something we should have caught on the walk-through. And the work carries our 365-Day Done Right Promise: if it’s not done right, we make it right.
DIY or Call Us?
You can safely check three things yourself: look for cracked pavers, clear debris from roof drains and scuppers, and glance at the ceiling after heavy rain with a flashlight. Those observations help you describe the problem accurately when you call. What you shouldn’t do is lift pavers to inspect the membrane, apply roof patch to an EPDM seam, or walk a low-slope roof after rain. A slipped foot on wet membrane is a hospital visit, and a DIY patch on a seam often makes the eventual professional repair harder and slightly more expensive.
If you’re in West Palm Beach and you’ve found a failing paver, a wet ceiling, or a membrane that looks tired, call (728) 203-3270 and describe what you’re seeing. We’ll tell you what it’s likely to be over the phone, and whether it’s worth having someone look before the next storm.
FAQs
A properly installed Unilock-compatible EPDM or TPO membrane on a flat roof in West Palm Beach typically lasts 15 – 20 years, with seam adhesives and pipe boots needing attention around years 12 – 15. Paver stones themselves last decades if the pedestals are kept intact. Salt air and intense UV cut lifespan by roughly a third compared to northern climates. If you’re at year 12 and haven’t had an inspection, call us at (728) 203-3270 and we’ll look for early seam failure before it leaks.
Most first-time failures can be repaired: a separated seam, a cracked pipe boot, a few broken pedestals. We’ll always show you what failed and tell you honestly if a patch buys you three years or zero. If the membrane is blistered in multiple areas or the seams are failing repeatedly, repair becomes throwing good money after bad. Estimates are free, so you’ll never have to guess.
Most West Palm Beach Unilock-compatible roof repairs take one visit, usually four to six hours, including clean-up. A full membrane replacement typically runs three to five days depending on decking condition and weather windows. We schedule quiet work hours where we can and leave the site cleaner than we found it, with a photo of the clean-up before the crew leaves.
We stock common EPDM and TPO seam tapes, termination bars, pipe boots, and pedestal sets, and we pull pavers from local distributors in Riviera Beach and West Palm Beach as needed. KraftMaid, Cambria, and Silestone are other brand lines we stock parts and materials for, but roofing parts come from roofing supply houses, not the remodeling showroom. If we don’t have your exact paver series in stock, we’ll tell you the lead time before you commit to anything.
Written by Graham Stein, Owner, Elmstead Remodeling West Palm Beach at Elmstead Remodeling West Palm Beach, serving West Palm Beach and nearby areas.
