Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Fence Installation: The West Palm Beach Owner’s Guide
ActiveYards fence installation in West Palm Beach typically costs between $3,500 and $9,000 for a full yard, with most homeowners landing around $5,500 for a standard lot. We match replacement sections, posts, gates, and hardware to your existing ActiveYards series, and we stock the most common components on our trucks so a repair visit usually means one trip instead of three. Most West Palm Beach owners discover a problem the same way: a gate that drags after a heavy rain, a post that’s started leaning toward the neighbor’s side, or a section that hums in an afternoon thunderstorm wind and doesn’t stop.
What makes ActiveYards worth repairing rather than replacing is the aluminum construction. It does not rust the way steel does, and the factory finish holds up to salt air from the Intracoastal far better than most powder-coated competitors. But aluminum also flexes, and West Palm Beach’s combination of sandy soil, summer downpours, and the occasional hurricane-force gust finds every weak point within a few seasons. When a post shifts or a gate sags, we write down exactly what is failing and why before we touch a single allen wrench. That’s the way Graham Stein has run our West Palm Beach crew since day one: put it in writing, then do exactly that.
Which ActiveYards Models This Applies To
ActiveYards manufactures several series, and the parts are not always interchangeable across them. The most common installations we see in West Palm Beach are the Dogwood, Greenwood, and Cypress aluminum fence lines, plus the Americana series for taller privacy applications. Each series uses a specific post size, picket spacing, and bracket system. A Dogwood gate bracket will not seat correctly on a Cypress post, and attempting to force it strips the factory channel.
The simplest way to identify your series is to open a gate and look for the small laser-etched mark on the hinge side of the frame, usually near the bottom rail. If that mark has worn off under Florida sun, we match by measuring the picket profile and post dimensions. ActiveYards posts run 2″ x 2″ or 2.5″ x 2.5″ depending on series, and the top picket punch pattern differs enough to identify a line in about five minutes. For the installation itself, we carry OEM ActiveYards components when the job requires exact factory matching. Where an aftermarket equivalent will hold the same line and accept the same bracket without a visible difference, we’ll tell you the price difference and let you choose. We are an independent West Palm Beach remodeling contractor, not an ActiveYards dealer, which means our goal is a fence that stays square, not a parts sale you don’t need.
- Cypress: 2″ x 2″ posts, narrower picket spacing, most common in West Palm Beach front yards for pool-code-friendly sightlines.
- Dogwood: 2″ x 2″ posts, wider picket spacing, the workhorse we see most in HOA-governed subdivisions like Flamingo Park and Sunshine Park.
- Greenwood: 2.5″ x 2.5″ posts with a heavier top rail, better for long runs with minimal support posts.
- Americana: tall privacy panels, 2.5″ x 2.5″ posts, requires concrete footings sized for wind load rather than standard post holes.
Styles & brands we work with
Signs Your ActiveYards Fence Installation Is Failing
- Gate drags across the concrete or grass on opening. The hinge-side post has shifted out of plumb, which usually means the original footing was too shallow for sandy West Palm Beach soil. Aluminum posts don’t bend so much as they move, and the gate reveals it first.
- Section hums or rattles in wind above 15 mph. The picket-to-rail punch connections have loosened or a bracket screw has stripped. ActiveYards sections are designed to flex, but loose fasteners turn that flex into the kind of noise you hear from the kitchen.
- Post leans toward the driveway or street before or after rain. Water has been pooling at the base of the post. In our West Palm Beach clay-and-sand mix, a post hole that drains poorly becomes a pivot point during the wet season.
- Black oxide streaks running down from brackets or screws. The factory finish is intact on the rails but the hardware is not factory spec, or the original installer swapped in steel fasteners. Stainless and coated hardware should never streak, even five years in.
- Gate latch no longer lines up with the striker plate by a quarter inch or more. The frame has racked slightly. It is a small misalignment now, but every opening grinds the latch tongue and eventually the gate will not hold closed at all.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a full ActiveYards fence installation in West Palm Beach, expect to budget between $3,500 and $9,000 depending on linear footage, series type, gate count, and whether existing posts can be reused or must be reset. A single gate replacement with new posts and hardware typically lands between $800 and $1,600 installed. A section swap to match an existing run runs $40 to $70 per linear foot depending on series height and picket spacing.
- Post replacement only (no section work): $180 – $320 per post, including concrete removal and proper re-bedding with drainage gravel.
- Gate rebuild with ActiveYards OEM hinges and latch: $650 – $1,400 depending on width and whether the frame itself is warped.
- Section install to match existing ActiveYards series: $40 – $70 per linear foot, including factory-matched pickets, rails, and brackets.
- Full yard install, standard 150 – 200 linear feet: $3,500 – $9,000 with posts set in concrete per county wind-load requirements.
Every quote includes the written line-item price before work starts. That means the part cost, the labor, the concrete, and the disposal are on paper in your hand before our crew unloads a single tool. The 365-Day Done Right Promise covers the completed work: if a post settles or a gate drifts within the first year, we return and make it right without a second invoice.
DIY or Call Us?
There are checks an owner can do safely: visually confirm whether a post is plumb with a level, look for black streaks from hardware, and test whether the gate latch binds. Those observations help you decide what to call in. The actual repair is where it goes wrong fast. Aluminum gate frames carry significant tension on the hinge side, and a post that is leaning has usually undermined the concrete footing, which means digging it out correctly requires knowing how deep West Palm Beach wind-load code wants it set. We are happy to talk through what you are seeing on the phone before we schedule anything. Call (728) 203-3270 and describe the symptom. If it is a quick adjustment, we’ll say so. If it needs a crew, we’ll tell you exactly what they will do and what it will cost before they arrive.
FAQs
With properly set concrete footings and OEM or factory-equivalent hardware, an ActiveYards aluminum fence in West Palm Beach should hold its lines and finish for 20 to 25 years. The parts that fail first are fasteners and gate hinges, not the aluminum sections. Call (728) 203-3270 if your fence is under 10 years old and showing problems, it usually means an installation issue, not a material issue.
Sometimes. If the post itself is not kinked or cracked, it can often be plumbed and re-bedded in a properly drained footing. If the concrete has shifted in sandy soil, we may need to reset the post entirely rather than shim it. We’ll know which path is viable once we see how the base was originally poured.
Most standard yard installations in West Palm Beach run two to four working days from first post hole to final gate adjustment. Replacement sections or a single gate rebuild often finish in one day. We schedule concrete pours for a stretch of dry weather so the posts cure correctly, not just quickly.
We keep common ActiveYards-compatible hinges, latches, brackets, and post caps on our West Palm Beach trucks. Series-specific rails and pickets sometimes require a factory order, which adds three to seven business days. We’ll confirm availability and lead time on your written quote before any work is scheduled. Call (728) 203-3270 with your model info and we’ll give you an exact answer.
Written by Graham Stein, Owner, Elmstead Remodeling West Palm Beach at Elmstead Remodeling West Palm Beach, serving West Palm Beach and nearby areas.
